The Submersible Slurry Pump Used Into Solid Control

KOSUN submersible slurry pump have vertical single stage and single suction system overhung structure, adopt wear-resistant alloy material, convey medium with high concentration particle. No bearing and shaft seal between impeller and pump body, so it is free-maintenance, high temperature resistance, it is the ideal equipment to provide impetus for desander, desilter and decanter centrifuge.

Submersible Slurry Pump is the cantilever pump structure of single stage and single suction, with the bearing housing, supporting, intermediate pipe connecting the pump hydraulic components, the water is discharged out from the drain pipe parts, pump impeller is for semi-shrouded with the agitating vane on the vane extended KOSUN manufacturers KOSUN series submersible slurry pump that the main characteristic of this pump is the underwater pump shaft parts have enough rigidity, the impeller and pump shell have no bearings, no shaft seal, which can transport the greater medium of solid particles. The length of inserting the water by slurry pump is between 800 mm and 1900mm, the suction pipe can be matched in case of need. The shaft seal runs into the underwater pump without setting up the shaft seal, drive should be installed the vertical motor on the supporting seat connecting with coupling and pump.

Features & Benefits of Submersible Slurry Pump

1. The pump shaft under the liquid has enough rigidity. No bearing is set between impeller and pump. Shaft seal is not adopted, the medium with large density solids can also be transported.

2. The length of pump under the liquid between 800m-2500mm, match the suction piping if necessary. Vertical motor is installed on the motor base, connect coupling with pumps.